Configuration without software – Buffalo Technology WLI3-TX1-G54 User Manual

Page 8

Conﬁguration of the Ethernet Converter without software is possible. The following

steps will guide you through conﬁguring your Ethernet Converter without software.

◗

Refer to your operating system documentation on how to conﬁgure a 'Static' IP

Address. The Ethernet Converter has an IP Address of 1.1.1.1 by default. Thus,

for successful conﬁguration, the PC must be conﬁgured with 1.1.1.2 as its IP

Address.

◗

With the included network patch cable, plug the Ethernet Converter's LAN port

into an open port on your network's router, or on one of your network switches

or hubs. If there are no ports available, you can temporarily remove a computer

or other connected device and plug the Ethernet Converter to that port. You can

plug the Ethernet Converter directly to the conﬁguring computer.

◗

Once the network cable has been plugged in, plug the Ethernet Converter's AC

Adapter into an available power outlet. Then attach the power connector to the

back of the Ethernet Converter. The boot up process takes 30 seconds and can

be conﬁrmed completed when both the Wireless and Ethernet lights are green.

Configuration without Software