Pioneer DEH-P7100BT - Manual (Page 44)

Custom1 Custom 1
Custom2 Custom 2
Flat Flat
Super Bass Super bass
! Custom1 and Custom2 are adjusted equal-
izer curves that you create. Adjustments
can be made with a 7-band graphic equali-
zer.
! When Flat is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
Flat and a set equalizer curve.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Use MULTI-CONTROL to select the gra-
phic equalizer adjustment.
Powerful appears in the display.
If the equalizer curve has been previously se-
lected, the curve of that previously selected
will be displayed instead of
Powerful.
3 Push MULTI-CONTROL left or right to
select an equalizer curve.
Each time
MULTI-CONTROL is pushed left or
right, equalizer curves are selected in the fol-
lowing order:
Powerful
—Natural—Vocal—Custom1—
Custom2 —Flat—Super Bass
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
Flat, Custom1 and Custom2 can
be adjusted to a fine degree (nuance control).
1 Recall the equalizer curve you want to
adjust.
Refer to Recalling equalizer curves on the pre-
vious page.
2 Push MULTI-CONTROL up or down to
adjust the equalizer curve.
Each time
MULTI-CONTROL is pushed up or
down, the equalizer curve increases or de-
creases respectively.
+6 to
–4 (or –6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 7-band graphic equalizer
For Custom1 and Custom2 equalizer curves,
you can adjust the level of each band.
! A separate Custom1 curve can be created
for each source. (The built-in CD player and
the multi-CD player are set to the same
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than
Custom2 is selected, the
equalizer curve settings will be memorized
in
Custom1.
! A Custom2 curve can be created common
to all sources. If you make adjustments
when the
Custom2 curve is selected, the
Custom2 curve will be updated.
1 Recall the equalizer curve you want to
adjust.
Refer to Recalling equalizer curves on the pre-
vious page.
2 Use MULTI-CONTROL to select 7-band
graphic equalizer adjustment.
Frequency and the level (e.g.,
50Hz LV+4) ap-
pears in the display.
3 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time
MULTI-CONTROL is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
50Hz
—125Hz—315Hz—800Hz—2kHz—
5kHz
—12.5kHz
Audio Adjustments
En
44
Section
10