Pioneer DEH-P7100BT - Manual (Page 25)

For details about the supported iPod, refer to
iPod compatibility on page 65.
Basic Operations
% Fast forward or reverse
Push and hold
MULTI-CONTROL left or right.
% Select a track (chapter)
Push
MULTI-CONTROL left or right.
Notes
! When using an iPod, iPod Dock Connector to
USB Cable (CD-IU50) is required.
! Read the precautions for iPod in the following
section. Refer to page 65.
! If an error message is displayed, refer to Error
messages on page 62.
! When the ignition switch is set to ACC or ON,
the iPod
’s battery is charged while the iPod is
connected to this unit.
! While the iPod is connected to this unit, the
iPod cannot be turned on or off.
! Before connecting the dock connector of this
unit to the iPod, disconnect the headphones
from the iPod.
! The iPod is turned off about two minutes after
the ignition switch is set to OFF.
Browsing for a song
Searching songs by category
Operations to control an iPod with this unit is
designed to be as close to the iPod as possible
to make operation and song search easy.
! Depending on the number of files in the
iPod, there may be a delay when displaying
a list.
! If the characters recorded on the iPod are
not compatible with this unit, those charac-
ters are not displayed.
1 Press /LIST.
2 Use MULTI-CONTROL to select a cate-
gory.
Turn to change the category. Press to select.
Playlists (playlists)/Artists (artists) —Artists
(artists)/ Albums (albums)
—Albums(albums)/
Songs (songs)
—Songs (songs)/Podcasts
(podcasts)
—Podcasts (podcasts)/Genres
(genres)
—Genres (genres)/Composers (com-
posers)
—Composers (composers)/
Audiobooks (audiobooks)
—Audiobooks
(audiobooks)/ Playlists (playlists)
List for the selected category is displayed.
# You can start playback throughout the se-
lected category by pressing and holding
MULTI-CONTROL. You can also perform this op-
eration by pushing and holding
MULTI-CONTROL right.
# You can also change the category by pushing
MULTI-CONTROL up or down.
# You can also select the category by pushing
MULTI-CONTROL right.
# To return to the previous category, push
MULTI-CONTROL left.
3 Repeat step 2 to find a song you want
to listen to.
# To return to the top tier of categories, push
and hold
MULTI-CONTROL left.
# If you do not operate the list within about 30
seconds, the display automatically returns to the
ordinary display.
Searching songs by alphabet
1 Press /LIST.
2 Use MULTI-CONTROL to select a cate-
gory.
Turn to change the category. Press to select.
3 Press /LIST to switch to alphabet
search mode.
4 Turn MULTI-CONTROL to select a letter
of the alphabet.
5 Press MULTI-CONTROL to display the al-
phabetical list.
While searching,
Searching flashes.
# If alphabet search fails, NOT FOUND is dis-
played.
Playing songs on iPod
En
25
Section
07
Playing
songs
on
iPod