Pioneer AVIC-HD3 - Manual (Page 13)

11
Ch
ap
te
r 2
H
o
w
to
U
se
th
e N
av
ig
ati
on
S
ys
te
m
a
n
d
N
am
es
o
f t
h
e Pa
rt
s
When Using the Navigation
System for the First Time
The navigation system cannot detect the location
correctly if the initial learning is not complete.
The correct positioning can be attained after
driving a certain distance. (The AV source can be
used normally regardless of the initial learning
status.)
When the vehicle starts to run, the 3D Hybrid
Sensor’s initial learning automatically starts.
Until the 3D Hybrid Sensor’s initial learning is
complete, the positioning is performed by GPS
satellites so the location of your vehicle may not
be very accurate. This is not an error. When the
initial learning is complete, the location of your
vehicle can be detected with high accuracy.
❒ When an error message appears during the
initial learning, refer to “Message and how to
react to them” in the Operation Manual.
Selecting a Source with the AV
Button
1
Turn the ignition switch (ACC) ON.
The navigation system’s power supply comes
on.
2
After the navigation system starts, press
the AV button to switch the screen.
The navigation map screen changes to the
audio source screen.
3
Press the AV button to turn the audio
source on.
4
Press the AV button to select a source.
Press the AV button repeatedly to switch
between the following sources:
[CD/ROM (MP3)/DISC] (built-in DVD drive) –
[LIBRARY] (HDD player) – [FM] (FM tuner) –
[AM] (LW/MW tuner) – [iPod] (iPod) – [M-
CD] (multi-CD) – [TV] (television) – [AV
INPUT] (video input) – [AUX] (auxiliary
equipment) – [EXT 1] (external unit 1) – [EXT
2] (external unit 2)
❒
Press and hold the AV button to turn the
source off.
❒ In the following cases, the sound source
cannot be used:
– When a unit corresponding to the source is
not connected to the navigation system.
– When no disc is set in the navigation
system.
– When no magazine is set in the multi-CD
player.
– When [AUX Input] (auxiliary input) is
turned off (refer to Operation Manual).
– When [AV Input] (video input) is not set to
[Video] (refer to Operation Manual).
❒ “External unit” refers to a Pioneer product
(such as one available in the future) where,
although it is incompatible as a source, the
basic functions can be controlled by the
navigation system. Two external units can be
controlled by this product. When two external
units are connected, the product allocates
them to external unit 1 or external unit 2.
❒ When the [Auto ANT] mode is set to
[Radio], the vehicle’s antenna can be stowed
or turned off by following one of the steps
below.
– Change the source from radio (AM or FM)
to another source.
– Turn the source off.
– Turn off the ignition switch (ACC OFF).
If the [Auto ANT] mode is set to [Power], the
vehicle’s antenna can be stowed or turned off
only when the ignition switch is turned off
(ACC OFF).
➲
[Auto ANT] ➞ Operation Manual
Adjusting the Volume
• Use the VOL (8/2) button to adjust the
audio sound level.
Press the VOL (8/2) button to increase or
decrease the volume.
❒
To adjust the navigation volume, go to the
navigation menu.
➲ Navigation volume adjustment ➞
Operation Manual
MAN-HD3-HARDW-EN.book Page 11 Thursday, January 25, 2007 10:14 AM