Pioneer DEH-2210UB - Manual (Page 4)

Basic Operations
Important
! Handle gently when removing or attaching
the front panel.
! Avoid subjecting the front panel to excessive
shock.
! Keep the front panel out of direct sunlight and
high temperatures.
! Remove any cables and devices attached to
this unit before detaching the front panel to
avoid damage to the device or vehicle interior.
Removing the front panel to protect your unit from
theft
1 Press
to release the front panel.
2 Grab the front panel and remove.
3 Put the front panel into the provided protective
case for safe keeping.
Re-attaching the front panel
1 Slide the front panel to the left until it clicks.
Front panel and the head unit are connected on
the left side. Make sure that the front panel has
been properly connected to the head unit.
2 Press the right side of the front panel until it is
firmly seated.
If you can
’t attach the front panel to the head unit
successfully, try again. However, forcing the front
panel into place may result in damage.
Turning the unit on
1 Press SRC/OFF to turn the unit on.
Turning the unit off
1 Press SRC/OFF and hold until the unit turns off.
Selecting a source
1 Press SRC/OFF to cycle between:
TUNER (tuner) —CD (built-in CD player)—USB
(USB)
—AUX (AUX)
Adjusting the volume
1 Turn M.C. to adjust volume.
Note
When this unit
’s blue/white lead is connected to
the vehicle
’s auto-antenna relay control terminal,
the vehicle
’s antenna extends when this unit’s
source is turned on. To retract the antenna, turn
the source off.
Menu operations identical
for function settings/audio
adjustments/initial
settings/lists
Returning to the previous display
Returning to the previous list (the folder one level
higher)
1 Press DISP/ /SCRL.
Returning to the main menu
Returning to the top tier of list
1 Press and hold DISP/ /SCRL.
Returning to the ordinary display
Canceling the initial setting menu
1 Press BAND/ESC.
Returning to the ordinary display from the list
1 Press BAND/ESC or .
Tuner
Basic Operations
Selecting a band
1 Press BAND/ESC until the desired band (F1, F2
for FM or MW/LW) is displayed.
Manual tuning (step by step)
1 Press c or d.
Seeking
1 Press and hold c or d, and then release.
You can cancel seek tuning by briefly pressing c
or d.
While pressing and holding c or d, you can skip
stations. Seek tuning starts as soon as you re-
lease c or d.
Operating this unit
En
4
Section
01