Blanco BC 75 X - Manual (Page 24)

24
Connection
Carry out the connection to the gas plant
only by means of a rigid metallic pipe
conforming to the regulations in force.
The joint for the entry of gas into the
appliance is threaded GJ 1/2".
Carry out the connection avoiding any type
of stress on the appliance.
Natual gas appliances must be fitted with a
pressure regulator and be installed at the
inlet connection. The gas pressure must
then be set as a part of the commissioning
procedures.
For U-LPG the pressure adjustment is
made via the regulator fitted at the domestic
cylinder.
Important
Upon completion of installation, always
check:
l
that all the joints are completely sealed
by using a soapy solution, never a flame;
l
that the gas pressure has been
regulated to 1.00kPa for Natural Gas
and 2.75kPa for Universal-LPG. The
pressure test point is located on the
regulator for Natural Gas models or at
the top left hand rear of the cooker for
U-LPG models. The pressure should be
measured and adjusted with the Wok
burner on high flame;
l
that the automatic ignition system is
operating satisfactory on all burners,
both individually and in combination;
l
that the burners operate correctly, are
stable, without yellow tipping or
excessive noise on high and low flame.
Then demonstrate to the customer the
appiance operation and leave these
instructions.