Braun BC1400 V2 - Manual (Page 5)

5
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Carefully read the use instructions before use.
Important
• Plug your appliance into an alternating
current (~) outlet only and make sure that your
household voltage corresponds to the voltage
marked on the hairdryer.
• This appliance must never be used near
water (e.g. a filled wash basin, bathtub or
shower). Do not allow the appliance to
become wet
.
• Always unplug after use. Even switched off the
appliance presents a hazard when near water.
• For additional protection, it is advisable to install
a residual current device (RCD) with a rated
residual operating current not exceeding 30 mA
in the electrical circuit of your bathroom. Ask
your installer for advice.
• Care should be taken not to block the inlet and
outlet grill when the appliance is switched on. If
either grill becomes blocked, the appliance will
automatically cut out. After cooling for a few
minutes, it will switch back on automatically.
• Do not wrap the mains cord around the appli-
ance. Regularly check the mains cord for wear
or damage. The mains cord of the appliance
may only be replaced by an authorised Braun
Service Centre. Unqualified repair work can lead
to extreme hazards for the user.
Description
1 Switch
2 Filter
3 Cold shot button
4 Adapter
5 Volume attachment
6 Brush attachment
7 Air concentrator
Switch 1
0 = off
1 = gentle drying
2 = fast drying
Cold shot
To fix a style, shortly activate the cold shot
button
3 .
Easy-clean filter
Regularly wipe the filter 2 clean (C). For a thorough
cleaning, remove the filter and clean it under
running water.
Using the attachments
1 Attaching the adapter (A)
• Align the markings (a), attach the adapter to the
hairdryer and turn it clockwise (b) until it snaps
into place.
• To remove the adapter, turn it anti-clockwise
and pull it off.
2 Connecting / changing the attachments (B)
• Choose an attachment (volume attachment or
brush attachment).
• Slide the attachment onto the adapter upwards
or downwards along the guiding grooves.
• To remove it, pull off the attachment upwards or
downwards.
3 Use
• For long-lasting styling results we recommend
that you apply a styling product (e.g. mousse)
and use the hairdryer on switch setting «1».
3.1 Volume attachment
• Using the volume attachment
5 , you can add
volume and root lift to your hair.
• Place the volume attachment with the fingers
against your head.
• Gently move the attachment back and forth
over a small section until the hair moves up the
fingers. Hold the attachment in place until the
hair gets dry. Continue section by section.
3.2 Brush attachment
• The brush attachment
6 is ideal for untangling,
slightly shaping and brushing your hair while
drying, thus leaving your hair smoother and
shinier.
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
Please do not dispose of the product in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points provided
in your country.
English
3519066_BC1400_V2_S4-34 Seite 5 Dienstag, 11. April 2006 3:08 15