Bradley Smoker WF2708 - Manual (Page 11)

Classic Circular 36"/54" Washfountain with Foot Control
Installation Instructions WF2605, WF2608 Terrazzo — WF2705, WF2708 Stainless Steel
Bradley Corporation • 215-603 Rev. M; EN 06-915B 11 4/6/2007
Installation Instructions continued . . .
Step 5a: Installing Supplies with Optional Soap Dispenser for A/O drain units
NOTE: See Step 5b for units with type B/H drain.
NOTE: For models with optional paper towel dispensers, tie pipe assembly, or shroud, see separate
instruction sheets and Step 5b for units with type B/H drain.
NOTE: Flush the supply lines before making connections.
1. Install the hemmed end (not sharp end) of the support tube with the gasket into the bowl.
2. Using pipe sealant, connect the supply pipe to the sprayhead and place on top of the support tube as
shown in Figure 8 on page 12.
3a . For Unit with Soap Option:
1. Place the upper tie bar on top of the sprayhead and join the upper and lower tie rod (the longer threaded
rod) with the coupling nut and setscrews.
2. Insert the tie rod assembly through the hole in the upper tie bar and secure with the lower tie bar, tie rod
nut and setscrew from below (see Figure 8).
3. Install the spacer, soap dispenser, dispenser cover and secure with the acorn nut and socket setscrew.
4. Continue installation with Step 7 on Page 16.
3b . For Unit without Soap Option:
1. Place the dispenser cover on the sprayhead. Thread the acorn nut onto the lower tie rod, run the tie rod
through the dispenser cover and secure from below with the lower tie bar, tie rod nut and socket setscrew
(see Figure 8).
2. Continue installation with Step 6 on Page 15.