Bulldog Security INSTALLATION GUIDE OWNER'S GUIDE - Manual (Page 5)

24 5
Your system includes:
1-Installation & Operation Guide
1-Main Control Module
1-Four Button Remote Transmitter
with Slide Protector
1-(4) Relay Harness with Relays
1-18-Pin Wire Harness
1-Hood Pin Switch
1-Extended Range Antenna (E Models Only)
SYSTEM COMPONENTS
REQUIRED TOOLS
2-Window Clips
(E Models Only)
1-Warranty
1-Warning Sticker
for Under the Hood
2-Bulldog Window Decals
TECHNICAL ASSISTANCE
BEFORE YOU BEGIN
Congratulations, you have purchased one of the most advanced
remote starter systems ever made. Your new remote starter is
a technological breakthrough utilizing the most advanced, state-
of-the-art technology and components. It is computer controlled
and manufactured in the U.S.A. The dependability and variety
of features make Bulldog Security the leader in the industry.
Enjoy your new remote starter for years to come!
This remote system is designed to start your vehicle by sending
a command signal from the remote transmitter or by programming
automatic temperature or timed start. It is required that your
installation be done in a well-ventilated area. It is the
responsibility of the owner to ensure that the remote system
is not used to start the vehicle in an undesired location.
Should you need help. First check our website at www.jbstech.com or call
our toll-free Tech Support Hotline Monday through Friday 9AM-8PM and
Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
• Name
• Telephone Number with Area Code (Fax number if applicable)
• Year, Make, and Model of the vehicle
• The model number of the system you are installing
• The type of assistance you are requesting
If you give the above information you will be called back as soon as
possible, usually within 10 minutes.
You will need a computer-friendly test light and a 5/16 inch
drill bit when mounting the hood pin switch. In most cases
no additional tools are required, however if the bottom of
your dash on the driver’s side will come off you must remove
it. In this case a screwdriver or socket set may be needed.
VEHICLES WITH FACTORY
ANTI-THEFT SYSTEMS
(CONT.)
FCC ID: J3STXJS1194
This device complies with part 15 of the FCC Rules,
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Manufacturer Make/ Year Anti-theft
PONITAC BONNIEVILLE 89+ VATS
FIREBIRD 88+ VATS
GRAND AM 96-98 PASSLOCK 1
GRAND AM 99+ PASSLOCK 2
GRAND PRIX 92-96 VATS
MONTANA 99+ TRANSPONDER
SUNFIRE 96-99 PASSLOCK 1
SUNFIRE 2000+ PASSLOCK 2
PORSCHE ALL 97+ TRANSPONDER
SAAB ALL 97+ TRANSPONDER
SATURN ALL 97+ FACTORY
2000+ TRANSPONDER
TOYOTA AVALON 98+ TRANSPONDER
CAMRY 98+ TRANSPONDER
LAND CRUISER 98+ TRANSPONDER
SOLARIA 99+ TRANSPONDER
SUPRA 98+ TRANSPONDER
VOLKSWAGON BEETLE 98+ TRANSPONDER
GOLF 98+ TRANSPONDER
PASSAT 98+ TRANSPONDER
VOLVO ALL 98+ TRANSPONDER