Olympus UFL-2 - Manual (Page 22)

EN 22
EN
Connecting using an underwater TTL cable (optional) and hot
shoe cable (optional)
1 Verify that the flash is completely dry.
2 Remove the cap of the TTL cable connector on the flash. Inspect the O-ring
and apply a thin coating of the supplied silicon grease.
3 Remove the cap from the TTL cable’s connector.
4 Align the TTL cable’s plug and the TTL cable connector on the flash at their
alignment marks and insert the cable straight.
5 Turn the lock dial on the cable’s connector until it stops to firmly attach the
connector.
6 In the same way, attach the TTL cable’s plug to the TTL cable connector on
the camera’s underwater case.
• For details about connecting the hot shoe cable (optional), refer to
the instruction manual of the camera’s underwater case.
The following optional accessories are recommended.
Underwater fiber optic cable PTCB-E02
Underwater TTL cable PTCB-E01
Hot shoe cable PHCB-01
Alignment mark
r2090_e_00.book Page 22 Thursday, May 1, 2008 6:29 PM