Olympus ZUIKO DIGITAL ED 300mm 12-8 - Manual (Page 3)

15 14
*
*
Attaching the Lens Strap
Nomenclature
①Focus stop buttons (x4)
②Drop-in filter
③Mounting index
④Rear cap
⑤Strap attachment
⑥Focus limit switch
⑦Focus ring
⑧Filter mount thread
⑨Hood attaching section
⑩Electrical contacts
⑪Tripod mount
Attaching the Lens Hood LH-120
Filters
The lens comes with the following filters.
①Standard clear filter SCF-43 .... Always mount this filter when not using any
of the other filters.
②ND4-43 .................................... Decreases the amount of light entering the
lens by 1/4.
③ND8-43 .................................... Decreases the amount of light entering the
lens by 1/8.
④Drop-in PL filter DPF-43
This filter eliminates surface reflected light.
The amount of reflected light eliminated can be adjusted with a rotary lever.
Attaching the Lens Case Strap
Fit the claws inside the lens hood securely
into the grooves in the hood mounting sec-
tion and then tighten the mounting screw.
After putting the hood on the lens as shown,
fit the claw inside the lens hood securely
into the grooves in the hood mounting sec-
tion and then tighten the mounting screw.
* Before mounting the lens hood on the lens or before storing them, loosen the mounting screw
until it stops.
Mounting screw
Mounting claws
Pull the end of
the strap at least
5 cm away from
the buckle.
Pull the end of
the strap at least
5 cm away from
the buckle.