Olympus UFL3 User Manual
Page 30
EN 29
EN
Q3:
How to handle the flash after use?
A3:
Refer to P.28.
Q4:
What are the causes for entry of water?
A4:
The main causes for the entry of water are shown below. Please
check them most carefully.
1
Forgetting to install the O-ring
2
The O-ring is partly or completely outside the groove
3
Damage, deterioration, or deformation of the O-ring
4
Sand, fibers, hair or other foreign matter on the O-ring
5
Sand, fibers, hair or other foreign matter on the O-ring groove or the
O-ring contact surface
6
Throwing the flash from a boat into the water, jumping with the flash
into the water, or other sudden application of strong forces onto the
flash. When entering the water, hand the flash over gently or avoid
impacts in other ways.
UFL-3_EN.book Page 29 Thursday, July 17, 2014 5:21 PM