Olympus DM-550 - Manual (Page 61)

61
4
a
M
en
u s
et
tin
g m
et
ho
d
[Time] setting:
1 Press the 9 or 0 button to
select "Hour"and "Minute" in the
[Start Time] and "Hour" and "Minute"
in the [Stop Time].
2 Press the + or – button to set.
3 Press the OK button to exit [Time]
selection.
[Rec Mode] setting:
Regardless of the regular [Rec Mode] (☞
P.47), timer recording will start in a set
recording mode.
1 Press the + or – button to select a
recording mode.
2 Press the OK or 9 button.
3 Press the + or – button to select a
recording rate.
4 Press the OK button to exit Recording
mode selection.
[Folder] setting:
1 Press the + or – button to select the
destination to save to (Memory) (For
DM-550)
2 Press the OK or 9 button to move
to the [Folder] setting.
3 Press the + or – button to select the
destination to save to (Folder).
4 Press the OK button to exit [Folder]
setting selection.
[Mic Sense] setting:
Regardless of the recorder’s microphone
sensitivity setting (☞ P.47), timer recording
will start at a set microphone sensitivity.
1 Press the + or – button to select from
[High], [Middle], and [Low].
2 Press the OK button to exit [Mic
Sense] selection.
6 Completing the setting.
1 Pressing + or − button to select
[Finish].
2 Press the OK button to complete the
setup screen.
Programmed settings will be applied
and the screen will return to the preset
number selection menu. If the [On/Off]
setting is set to [On], will appear on
the display.
a When setting to [On]
Menu setting method
When setting other preset numbers,
repeat Steps 2 through 6.
When the 9 button is pressed in the
Select in Advance Menu, the settings
selected can be confirmed.
7 Press the F or STOP 4 button to
complete the setting.
• The will appear on the display.
Notes
• If the recorder is in use at the preset start
time, the timer recording will start directly
after stopping the recorder.
• Even if the power if turned off or the recorder
is put on Hold, timer recording will start at a
specified time.
• If three timer recordings have the same
starting times, [Preset 1] has the highest
priority and [Preset 3] has the lowest.
• If the starting time for timer recording and
alarm playback (☞ P.64) is set for the same
time, timer recording will have priority.
• If the batteries run out while recording
based on the timer setting, the recorder will
stop recording. Check the battery power
before starting the timer recording.