Olympus PTEP12 - Manual (Page 3)

EN 2
EN
WARNING
1 Keep this product out of the reach of babies, infants, and children. There is the possibility of
occurrence of the following types of accidents.
• Injury by dropping onto the body from heights.
• Injury from parts of the body getting caught in parts which open and close.
• Swallowing of small parts, O-ring, silicone grease and silica gel. Please consult a physician
immediately if any parts have been swallowed.
2 Do not store digital camera with batteries inserted in this product.
Storage with a battery inserted may lead to leakage of the battery liquid and fire hazard.
3 If leakage of water should occur with a camera installed in this product, quickly remove the battery
from the camera. There is the possibility of ignition and explosion from generation of hydrogen gas.
4 This product is made of resin. There is the possibility that injuries may be caused when it becomes
broken due to strong impact with a rock or other hard objects. Please handle it with sufficient care.
CAUTION
1 Do not disassemble or modify this product. This may cause water leakage or defect. In case of the
loss of image data caused by disassembly, repair or modification etc. by any party other than those
appointed by OLYMPUS IMAGING CORP., we shall bear no responsibility for damage.
2 Use or storage of the product at the following locations may cause defective operation, defects,
damage, fire, internal fogging, or water leakage. This should be avoided.
• Locations reaching high temperatures such as those under direct sunlight, in an automobile, etc.
• Locations close to fire
• A water depth in excess of 45 m
• Locations subject to vibrations
• Locations with high temperature and humidity or with extreme temperature changes
• Locations with volatile substances
3 Opening and closing at locations with much sand, dust, or dirt may impair the waterproof
characteristic and cause water leakage. This should be avoided.
4 This product is not a case to soften impacts to the camera inside the product. When this product with
a digital camera inside is subjected to impacts or heavy objects are placed onto it, the digital camera
may be damaged. Please handle it with sufficient care.
5 Do not use the following chemicals for cleaning, corrosion prevention, prevention of fogging, repair
or other purposes. When these are used for the Case directly or indirectly (with the chemicals in
vaporized state), they may cause cracking under high pressure or other problems.
Chemicals which cannot be
used
Explanation
Volatile organic solvents,
chemical detergents
Do not clean the Case with alcohol, gasoline, thinner or other volatile
organic solvents or with chemical detergents etc. Pure water or
lukewarm water is sufficient for cleaning.
Anticorrosion agent
Do not use anticorrosion agents. Pure water is sufficient when washing
the metal parts as stainless steel and brass are used.
Commercial defogging
agents Do not use commercial defogging agents. Always use the specified
desiccant silica gel.
Grease other than specified
silicone grease Use only the specified silicone grease for the O-ring, as otherwise the
O-ring surface may deteriorate and water leakage may occur.
Adhesive
Do not use adhesive for repairs or other purposes. When repair is
required, please contact a dealer or a service station of OLYMPUS
IMAGING CORP.
PT-EP12_EN.Book Page 2 Thursday, June 5, 2014 7:14 PM