Beko WM 6133 W - Manual (Page 22)

22 EN
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the “On/Off” button.
2. Select the programme and the
temperature.
3. If required (according to your
machine’s model):
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press “Start/Pause/Cancel” button.
Canceling a program
• Press “Start/Pause/Cancel” button
for 3 seconds. At the end of this
time, “Start/Pause/Cancel” light
and all lights go off and “Spin” lamp
illuminates. If the door is unlocked, all
lights on the indicator will go off and
the “Ready” lamp will light. You can
select and start a new program when
“Ready” light illuminates.
• The machine can drain all the water
or can take in water for 3 times at
most to cool down the clothes and
complete the draining process. Also
the “Spin” light illuminates if the
cancellation process is activated
in the middle of the program. The
“Spin” light goes off when discharging
process is completed. The door can
be opened and a new program can
be selected when the “Ready” lamp
illuminates.
Adding more laundry
• This is only possible under the
following conditions:
– during time delay,
C You may add or remove laundry
during the time delay (until the
program starts).
– At the beginning of a washing cycle,
C Machine allows adding more laundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
of the program:
1. Press “Start/Pause/Cancel” button.
Wait until the door is allowed to
open. When the “Ready” lamp is on
continuously, continue to the next
step.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press “Start/Pause/Cancel” button.
Program is in rinse hold mode
C Clothes may be left to soak in the
machine as long as desired after
filling during the last rinse step. When
it reaches this position while the
machine is running, the “Start/Pause/
Cancel” light will flash.
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button. Program
resumes. Your machine drains the water
and spins your laundry.
If you want to discharge the water
without spinning:
Press “Start/Pause/Cancel” button. The
program continues and only drains
the water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in machine.
2. Select the spin program.
3. Set the spin speed if spin speed
adjustment is available on your
machine.
4. Press “Start/Pause/Cancel” button.
6 Quick instructions for daily use