Beko WM 6133 W - Manual (Page 21)

21 EN
“Start/Pause/Cancel” button and
switch the machine to “Pause” mode
in order to change the spin speed
or temperature. New spin speed or
temperature can be selected.
Adding/removing laundry in standby
mode
If you want to add more laundry into the
machine after the washing cycle has
started, put the machine into “Pause”
mode by pressing the “Start/Pause/
Cancel” button. The “Ready” lamp on
the program follow-up indicator will light
up after 1-2 minutes if the water level in
the machine is suitable. Laundry may be
added or taken out by opening the door.
If the “Ready” lamp does not light up
continuously at the end of this time, the
water level in the machine is not suitable
and laundry cannot be added. You can
resume the program by pressing the
“Start/Pause/Cancel” button again.
Child-proof lock
There is a childproof lock to prevent
any program interruption because of
pressing the keys while the program is
on.
C Your machine can be turned on and
off with On/Off button while the child-
proof lock is activated. In this case,
your machine will resume its program
with child-proof lock activated.
In order to activate the childproof
lock, press on the 1st and 2nd
auxiliary function keys from the left
simultaneously for 3 seconds after
the washing program has started.
1st auxiliary function light will flash
continuously.
To start a new program after the
program is over or to interfere the
program, childproof lock should be
deactivated. To deactivate the child-
proof lock, press the same buttons for
3 sec.
Ending the program through
canceling
The program which is selected first will
keep on going even if the position of the
program selection button is changed. A
new program can be selected or started
after “Program is cancelled” in order to
change the washing program.
To cancel any selected program;
• Press “Start/Pause/Cancel” button
for 3 seconds. At the end of this
time, “Start/Pause/Cancel” light
and all lights go off and “Spin” lamp
illuminates. If the door is unlocked, all
lights on the indicator will go off and
the “Ready” lamp will illuminate. You
can select and start a new program
when the “Ready” light is lit.
• The machine can drain all the water
or can take in water for 3 times at
most to cool down the clothes and
complete the draining process. Also
the “Spin” light illuminates if the
cancellation process is activated in
the middle of the program. The “Spin”
light goes off when discharging
process is completed. The door can
be opened and a new program can
be selected when the “Lid” lamp
illuminates.
End of program
The “Ready” lamp on the program
follow-up indicator will light up when
the program comes to an end. The
door can be opened and the machine
becomes ready for a second cycle.
Press the “On/Off” button to shut down
the machine.