AEG SCS51800S1 - Manual (Page 17)

8.4 Ventilation requirements
The airflow behind the appliance must
be sufficient.
5 cm min.
200 cm 2
min.
200 cm 2
8.5 Door reversibility
WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
5. Tighten the lower pin on the
opposite site.
6. Install the spacer.
7. Install the door.
8. Tighten the upper pin.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket. In case you do
not want to carry out the
above mentioned
operations, contact the
nearest After Sales Service
Force. The After Sales
Service specialist will carry
out the reversibility of the
doors at your cost.
ENGLISH 17