Buffalo Technology LinkStation Pro - Manual (Page 3)

Press the power button on the front panel
to turn your LinkStation on.
Check the LINK/ACT LED on the front
of the LinkStation. If it’s lit, then your
LinkStation is connected properly. Please
turn to page 4 to continue setup.
If the LINK/ACT LED on the front of
LinkStation is not lit, your LinkStation is
not properly connected to your network.
Make sure that:
• both LinkStation and the hub, switch, or PC are powered on,
• the Ethernet cable is securely fastened to both devices, and
• the Ethernet cable is not damaged. To verify, try using another
Ethernet cable.
Step : Check your Connection
If problems persist, contact our technical support.