Technical data, Installation, Replacing the lamp – AEG SKZ81200F0 User Manual
Page 42: Closing the door, Positioning

Problem
Possible cause
Solution
The temperature regulator is
not set correctly.
Set a higher temperature.
Replacing the lamp
The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height
1225 mm
Width
560 mm
Depth
550 mm
Rising Time
12 h
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must
ensure that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
42
Technical data