beautypg.com

2 replacing the lamp, 3 closing the door, Installation – AEG SKS58800S1 User Manual

Page 24: 1 location, 2 positioning

background image

Problem

Possible cause

Solution

Many food products are
stored at the same time.

Store less food products at
the same time.

The door has been opened
often.

Open the door only if neces-
sary.

There is no cold air circula-
tion in the appliance.

Make sure that there is cold
air circulation in the appli-
ance.

If the advice does not lead

to the desired result, call the

nearest brand-mark service.

8.2 Replacing the lamp

Disconnect the plug from the mains

socket.
1. Remove the screw from the lamp

cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new

lamp of the same power and

specifically designed for household

appliances (the maximum power is

shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains

socket.

7. Open the door.

Make sure that the light comes on.

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective

door gaskets. Contact the After Sales

Service.

9. INSTALLATION

WARNING!

Refer to Safety chapters.

9.1 Location

Refer to the assembly

instructions for the

installation.

To ensure best performance, install the

appliance well away from sources of heat

such as radiators, boilers, direct sunlight

etc. Make sure that air can circulate freely

around the back of the cabinet.

9.2 Positioning

This appliance can be installed in a dry,

well ventilated indoor where the ambient

temperature corresponds to the climate

class indicated on the rating plate of the

appliance:

Climate
class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

www.aeg.com

24