AEG FW 5645 - Manual (Page 35)

English
35
• If the device has switched itself off after 90 minutes
of use, you can switch it back on my setting the
step switch to ‘OFF’ and then setting the desired
temperature level again.
PLEASE NOTE:
Unusual smells may occur during the first use. These
are harmless and will cease over the course of opera-
tion.
Step switch
You can choose the following settings:
Settings function
0 Off
1 Low. Light heat.
2 Medium
3 High
PLEASE NOTE:
You can identify the setting using the temperature
level controller.
Switching off
• Set the step switch to
0 (off).
• Remove the plug from the electricity supply after
use.
• The device will switch itself off after 90 minutes. This
saves energy and provides additional safety as the
foot warmer is never used without supervision.
Inner lining
1. First remove the plug from the electricity supply.
2. Take the inner lining out of the foot warmer.
3. You can wash the inner lining in the washing ma-
chine on a delicate cycle at 40 °C.
WARNING:
Warns of dangers to your health and indicates
possible risks of injury.
ATTENTION:
Indicates possible hazards to the device or other
items.
PLEASE NOTE:
Highlights tips and information for you.
Operating instructions
Operation
The product keeps your feet nice and warm
and relaxes them.
WARNING:
Always use the foot warmer with the inner lining. This
creates a minimum distance which protects against
overheating.
ATTENTION:
Do not cover the step switch. This can lead to mal-
functions.
Electrical connection
• Ensure that the device voltage (see label) and the
mains voltage are the same.
• Set the step switch to ‘OFF’ and the put the plug
into a properly installed socket.
Switching on
• Move the step switch on the controller to the de-
sired setting.
• The relevant temperature level will illuminate and
show that the device is in operation.
Cleaning
WARNING:
• Pull the plug out of the socket before each time you clean
the device.
• Only clean the device when it is cool. Risk of burns!
• Do not submerge the foot warmer with the step switch in
water. This could lead to an electric shock or a fire.
• Do not use any strong cleaning agents or solvents.
Please note the care instructions on the labels.