BT Studio 3100 - Manual (Page 13)

Using your phone
Switch the handset power on/off
1. To switch off, press and hold until the display goes off.
2. To switch the handset on, press and hold .
Make a call
1. Press . When you hear the dial tone, dial the phone number.
Preparatory dialling
1. Enter the phone number first. The number is shown in
the display.
2. Press to dial the number.
End a call
1. Press , or place the handset back on the base/charger.
Receiving calls
1. When the phone rings, press to answer the call, or if the
handset is on the base or charger, simply lift it to answer the call.
If you would rather press
after lifting the handset to receive
a call, you will need to switch Auto-answer off, see page 28.
13
BT Studio 3100 – Issue 2 – Edition 2 – 25.10.07 – 8474
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]
Caller Display
If you have subscribed to your
network’s Caller Display service, the
caller’s number (or name, if an exact
number match is found in the
phonebook) will also be displayed,
see page 22.
If you make a mistake as you enter the
number, press to delete a digit.
Call timer
After the first 15 seconds of your call,
the call timer is displayed.
At the end of your call, the total
duration is not shown for 5 seconds.
Dialling numbers quickly
Numbers can also be dialled direct
from the phonebook (page 18), the
calls list (page 23), or the redial list
(page 14).
8474 Studio 3100 UG Iss2 [2] 25/10/07 16:38 Page 13