BT 2120 - Manual (Page 36)

Connecting to a switchboard
When connecting your Synergy 2120
to a switchboard/PBX, you may need
to change the dialling mode from
TONE to PULSE.
The dialling mode is set to
TONE when the product is
supplied.
To change to PULSE.
Until display flashes Base
setting .
PIN Enter the 4-digit base station
PIN. Original setting 0000.
Until the display flashes
Dial mode
.
Until the display flashes
Pulse
.
To confirm setting.
To change the dialling mode
With some switchboards it
may be helpful to dial a
pause after entering the
PSTN pre-fix code eg: 9,11
etc. to enable you to get an
outside line. However, your
Synergy 2120 can enter a
pause automatically for you.
Until the display flashes
Base setting .
PIN Enter the 4-digit base station
PIN. Original setting 0000.
Until the display flashes
PSTN prefix .
KEYPAD Enter the pre-fix number
you want. This can be up to
5 digits.
To confirm the setting.
To enter a PSTN pre-fix code
Options
Options
Options
Options
Options
Options
Options
34
Del
Options
Del
Options
Del
Del
Options
Del
Please note
Each time the PSTN pre-fix code is
dialled a pause will automatically be
inserted before the telephone
number is dialled.
S
WIT
CHBO
ARD