AEG SR 4337 iP - Manual (Page 52)

52 ENGLISh
SNOOZE (4 on remote)
If the device was powered on via the timer, this function
can be delayed for about 9 minutes with the SNOOZE
button. After 9 minutes, the device will be switched on
again.
CLOCK (5/1)
To set the clock.
When you press this button, the time will be displayed
briefly.
MEMORY (6 on remote)
To save the stations and to set the programmed playback.
Program Playback
Program playback in desired sequence. (only in CD mode).
1. Press STOP button (8/14).
2. Press MEMORY button (6 on the remote). The display
will show “00 P01“ (“track“ P “memory position“) and
MEMORY. Use the / buttons (7/14) to select the
desired track and press MEMORY buttons agian. The
display will change to memory position P02.
For CDs in MP3 format:
Folder “F00” next to P01 , flashes on the display. First,
select the desired folder with the buttons FOLDER +/-
(21 on remote). For confirmation, press the MEMORY
button. T00 is displayed.
3. Use the / buttons to select the next track and
press MEMORY/CLOCK again. Repeat the steps until
you have selected all tracks.
NOTE:
If the memory capacity of the programmable title is
reached, “PROGFULL“ will be displayed.
4. Press the button (9/17). Playback starts. The dis-
play will show the first selected track number. Also use
this button to temporarily stop playback.
5. Press STOP button once to stop playback. The memory
will be kept.
6. For repeated playback of the programmes, press the
button.
7. To delete memory, please press STOP button twice.
MEMORY will no longer be displayed.
The device will stop automatically after all stored tracks
have been played. The program sequence will be kept in
the memory until you switch to another mode, remove
the CD from the compartment or switch off the device.
It is possible to combine program playback with the RE-
PEAT function. After programming and starting playback,
please press REPEAT button (13 on the remote) up to three
times; the functions can be applied as described under
“REPEAT”.
Playback of music files in MP3 format
This device allows the playback of music files in MP3
format. The device furthermore supports the common CD
types: CD, CD-RW, and CD-R.
Your device can play MP3 CDs. These are compressed CDs
that can store up to 200 tracks. Your device automatically
recognizes MP3 discs (the display will show total number
of tracks and folders). Please refer to chapter “Playing CD/
MP3” for playback of such CDs. You may program tracks
as already described under “Program playback”.
Please note:
There are many burning and compressing methods, as well
as differences in quality of CDs and burnt CDs.
Furthermore, the music industry does not apply fixed
standards (copy protection).
For that reason there might, in rare cases, occur problems
when playing CDs and MP3 discs. That is not a malfunc-
tion of this device.
Cleaning and maintenance
• Disconnect the mains plug before cleaning.
• You may wipe off external stains, using a slightly
damp cloth without any additives.
Troubleshooting
Symptoms Course Solution
CD can not be
played back.
CD is not inserted
or inserted incor-
rectly.
Ensure that the disc is
inserted with the label
facing upwards.
Batteries too
weak.
Insert new batteries
or operate the device
with the mains lead.
CD jumps
during
playback.
Check the disc for
ingerprints, dirt or
scratches.
Check the disc for
ingerprints, dirt or
scratches.
The unit does
not work.
The unit is blocked
and “hangs”.
Disconnect the mains
plug for approximately
5 seconds. Then switch
the unit back on.