AEG S66609CSX0 - Manual (Page 22)

Problem Possible solution
The lamp does not come
on. Close and open the door to make sure that the
lamp is not in standby.
The lamp is defective. Replace the lamp.
The compressor operates
continuously. Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
Make sure not to open and close the appliance
door too frequently.
Make sure not to put hot food in the appliance.
Wait until it becomes cool.
Make sure that the room temperature is not too
warm.
Water collects on the rear
plate of the fridge. It is normal that this occurs when the automatic de-
frosting operates.
Water collects in the
fridge. Make sure that the drain hole is not clogged.
Make sure that food or packaging do not prevent
the water to collect in the water container.
There is water on the
floor. The melting water outlet does not flow in the
evaporative tray above the compressor.
Attach the melting water outlet to the evaporative
tray.
The temperature in the
appliance is too cold Set the temperature knob to a lower position.
The temperature in the
appliance is not sufficient-
ly cold. Set the temperature knob to a higher position.
Make sure that the appliance door is closed.
Make sure not to put hot food in the appliance.
Wait for the food to become cool.
Make sure that the appliance is not too full.
The temperature in the
fridge is not sufficiently
cold. Make sure that there is cold air circulation.
There is too much frost. Make sure that the food is closed in special con-
tainers or packaging.
Make sure that the appliance door is closed.
Set the temperature knob to a lower position.
22 www.aeg.com