AEG SRC 4333 iP - Manual (Page 43)

43 ENGLISH
Manual
NOTE:
The manually set time is automatically overridden as
soon as an iPod/iPhone is plugged onto the docking
port.
1. Press the TIME SET button (15). The hours start flash-
ing.
2. Press the / buttons (2 on the RC), to set the hours.
Press the TIME SET button to confirm.
3. Press the / buttons to set the minutes.
4. Press the TIME SET button again to save the current
time setting.
NOTE:
• You can also set the time with the SET frequency
control (11 on the device).
• While the time is displayed, you can select between
12 hour and 24 hour display by holding down the
TIME SET button.
• 12 hour display shows:
AM = morning, PM = afternoon
iPod/iPhone Compatibility
Due to the large variety of iPod and iPhone models and
generations on the market, full compatibility cannot be
guaranteed. Before connecting your iPod/iPhone, ensure
that it has a compatible interface.
Full compatibility of the remote functions also cannot be
guaranteed. Operate your iPod/iPhone as normal, while it
sits in the docking station.
NOTE:
Depending on the software version of your iPhone the
following error message may be displayed:
“This accessory was not developed for iPhone use. It
is possible that noise occurs and signal strength is
reduced.”
In this case press “OK”
General Operation
NOTE:
Some buttons you can find as well on the device as on
the remote control.
Identical buttons efect the same function.
Switch device on/off (8/13)
By pressing the button, you can put the device into
standby mode. Pressing the button again will switch the
device on.
Display brightness
You can select or switch off the display brightness with
the DIMMER (SNOOZE/DIMMER) button (13/7).
NOTE:
The display brightness is automatically switched off
when you switch the device to Standby mode.
Volume
There are two options:
• Use the VOLUME control (6 on the device) to set the
desired volume.
• By pressing the +/- buttons (12 on RC) you can adjust
the desired volume.
Infrared Remote Control
For wireless control within a distance of 5m. If the
distance decreases you should change the batteries. For
proper operation mind a clear view between the remote
control and the sensor on the device.
MUTE (5)
For immediate muting of the volume. Press the MUTE
button again to cancel this function.
NOTE:
Due to technical reasons, the activated function is not
displayed.
Radio Tuning
• Press the button (8/13) to switch the device on.
• Repeatedly press AUDIO button (12/4) until the display
shows “FM”.
• Use the SET control (11) or the / buttons (12) to
tune in the desired station.
• If the reception is too weak and there is interference
on the channel, try to improve the reception by chang-
ing the position of the aerial and /or coil/uncoil it.
Save Radio Station
1. To save the station you have found, hold down the
PRESET button (10 on RC) for about 3 seconds. A
preset flashes on the display (e.g. 01).
2. Press the / buttons (3/5 on RC) to select a station
preset between 01and 20.
3. Briely press the PRESET button to save the radio sta-
tion.
Recall Saved Radio Stations
To select the saved radio station, first press the PRESET
button. Now use the / buttons to the select the stor-
age location.