AEG WUB 5511 - Manual (Page 41)

English
41
WARNING:
• If the device does not work because a fuse has been activated or
triggered, please return the product to our service department.
• Do not try to repair the appliance on your own. Always contact
an authorized technician. To avoid the exposure to danger, al-
ways have a faulty cable be replaced only by the manufacturer,
by our customer service or by a qualified person and with a
cable of the same type.
General notes
• The appliance is designed exclusively for private use and
for the envisaged purpose. This appliance is not fit for
commercial use. Do not use it outdoors. Keep it away
from sources of heat, direct sunlight, humidity (never dip
it into any liquid) and sharp edges. Do not use the ap-
pliance with wet hands. If the appliance is humid or wet,
unplug it immediately.
• When cleaning or putting it away, switch off the appli-
ance and always pull out the plug from the socket (pull
the plug itself, not the lead) if the appliance is not being
used and remove the attached accessories.
• Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
• Check the appliance and the cable for damage on a
regular basis. Do not use the appliance if it is damaged.
• Use only original spare parts.
• In order to ensure your children’s safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of
their reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid
accidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates pos-
sible injury risks.
CAUTION:
This refers to possible hazards to the machine or other
objects.
NOTE:
This highlights tips and information.
Overview of the Components
1 Control
2 Control switch
3 Power setting display with indicator lamp
Instructions for Use
Use
Use the electric blanket on the mattress of your bed. The
electric blanket must be attached to the mattress by means
of the straps.
• Place the electric blanket on the mattress (see Figure A).
• Release the straps and guide them under the mattress
(see Figure B).
• Pass the straps through the loops on the other side of the
electric blanket and fasten them with knots.
• The electric blanket must lie smoothly on the mattress
and must not be tucked in or contain any creases.
• Pass the lead out of the bed in such a way that you can
still operate the control switch.
CAUTION:
Do not cover the control switch with bedding or pillows!
Otherwise this might result in a malfunction.