English – AEG AR 4025 BT User Manual

Page 74

ENGLISH

Installing the unit into the ISO dashboard slot

Detach the mounting sleeve (D) and frame (B) from

the unit housing. Use the assembly keys (C) to do so.

Fit the mounting sleeve into the ISO dashboard slot.

Bend the mounting sleeve tabs round with a screw-

driver so that the frame is mounted securely in the

dashboard slot.

Check that the frame is secure.

Connect the ISO connection of the unit to the two ISO

connectors of your vehicle.

Connect the antenna cable of the vehicle antenna to

the antenna adapter of the unit.

If necessary, also secure your unit against theft.

Fasten the screws to the mounting bracket and to the

mounting material on the engine firewall of the car.

Slide the unit carefully into the mounting sleeve, until

it clicks into place.

After all connections have been made, press the

RESET

button (26) using a ballpoint pen or other pointed

object.

Attach the control panel (A), as described under

„Attach control panel“.

CAUTION:

Possible damage to the cables!

When inserting the unit, pay attention to the cable

►

routing to prevent damage.

Then mount the frame.

Disassemble the unit

To disassemble the unit, proceed as follows:

Remove the frame.

Insert the right and left hand assembly key into the

respective slots on the sides of the unit. (The tabs are

now bent back.)

Pull out the unit.

NOTE:

If the housing is uneven, the tabs on the mounting

►

sleeve may become jammed. Use the assembly keys

to release the tabs.

Installation for Toyota or Nissan

NOTE:

Mounting sleeve, frame and mounting strip are not

►

required.

Use the threaded mounting holes on the sides of the unit

(A), to fasten the unit to the mounting brackets (supplied

with your vehicle). The holes are labeled T (for Toyota) or

N (for Nissan).

Loosen the mounting screws for the left and right

hand catches on the front of the unit and remove the

catches.