beautypg.com

5 periods of non-operation, Troubleshooting, 1 what to do if – AEG S37020KSW0 User Manual

Page 10

background image

A certain amount of frost will always form

on the freezer shelves and around the

top compartment.
Defrost the freezer when the frost layer

reaches a thickness of about 3-5 mm.
1. Switch off the appliance, or pull out

electrical plug from the wall socket.

2. Remove any stored food, wrap it in

several layers of newspaper and put

it in a cool place.

WARNING!

Do not touch frozen

goods with wet hands.

Hands can freeze to the

goods.

3. Leave the door open.

In order to speed up the defrosting

process, place a pot of warm water in

the freezer compartment. In addition,

remove pieces of ice that break away

before defrosting is complete.

4. When defrosting is completed, dry

the interior thoroughly.

5. Switch on the appliance.

After three hours reload the previously

removed food into the freezer

compartment.

7.5 Periods of non-operation

When the appliance is not in use for long

periods, take the following precautions:
1. Disconnect the appliance from

electricity supply.

2. Remove all food.

3. Defrost (if necessary) and clean the

appliance and all accessories.

4. Leave the door/doors open to

prevent unpleasant smells.

WARNING!

If the cabinet will be kept on,

ask somebody to check it

once in a while to prevent

the food inside from spoiling

in case of a power failure.

8. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

8.1 What to do if...

Problem

Possible cause

Solution

The appliance does not op-
erate.

The appliance is switched
off.

Switch on the appliance.

The mains plug is not con-
nected to the mains socket
correctly.

Connect the mains plug to
the mains socket correctly.

There is no voltage in the
mains socket.

Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.

The appliance is noisy.

The appliance is not suppor-
ted properly.

Check if the appliance
stands stable.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the
lamp".

www.aeg.com

10