beautypg.com

Remote control, Inserting batteries into the remote control, The cr102 universal remote controller – Arcam AVR surround amplifier / AV processor AVR600 User Manual

Page 30

background image

E-28

Inserting batteries into the

remote control

1. Open the battery compartment by pressing the

button on the back of the handset.

2. Insert four ‘AAA’ batteries into the battery

compartment – two facing the top of the unit,

and two facing the end, as in the diagram.

3. Lower the end cap onto the plastic locating plate

in the handset. This acts as a hinge, and you

can now push the end cap firmly into its locked

position with a click.

The CR102 universal remote

controller

The CR102 is a sophisticated ‘universal’ backlit remote

control that can control up to eight devices. It is pre-

programmed for use with the AVR500, AVR600, AV888

and many other Arcam products (FM/DAB tuners, CD

players and DVD players).
With its extensive built-in library of codes, it can also

be used with thousands of third party audio-visual

components – TVs, satellite and set-top boxes, PVRs,

CD players, etc. See the list of codes at the back of this

handbook, beginning on page 60.
The CR102 is a ‘learning’ remote, so you can teach it

almost any function from an old single-device remote.

You can also program the CR102 to issue a sequence of

commands (‘macros’) from a single button press.

remote

control

Using the remote control

Please keep in mind the following when using the

remote control:

<

Ensure there are no obstacles between the

remote control and the remote sensor on the

front panel. The remote has a range of about 7

metres. (If the remote sensor is obscured, the Z1

IR remote control input jack on the rear panel is

available. Please consult your dealer for further

information.)

<

Remote operation may become unreliable if

strong sunlight or fluorescent light is shining on

the remote sensor of the unit.

<

Replace the batteries when you notice a

reduction in the operating range of the remote

control.

notes on batteries:

<

Incorrect use of batteries can result in hazards such

as leakage and bursting.

<

Do not mix old and new batteries together.

<

Do not use non-identical batteries together –

although they may look similar, different batteries

may have different voltages.

<

Ensure the plus (+) and minus (-) ends of each

battery match the indications in the battery

compartment.

<

Remove batteries from equipment that is not going

to be used for a month or more.

<

When disposing of used batteries, please comply

with governmental or local regulations that apply in

your country or area.

4

3

2

1

8

7

6

5

0

9

MCH

TAPE

SHIFT

iPOD

RPT

NET

TV

AV RND

PHONO

AUX

DVD

SAT

AV

TUN

AMP

PVR

VCR

CD

OK

CR102

MODE

DISP

MENU

EFFECT

DIRECT

EQ

BASS

SUB

TRIM

SYNC

TREBLE

INFO

HOME

FAVÐ

FAV+

SRCH

SUBT

AUDIO

TITLE

SETUP

CH