Arcam AVR surround amplifier / AV processor AVR600 - Manual (Page 28)

E-26
the audio will be down-mixed to two channels (2.0). The
two-channel down-mix is required so that the centre
channel and surround information can be heard via the
headphones.
Using Zone 2 and 3
Zone 2 provides the option for the occupants of the
master bedroom, conservatory, kitchen, etc. to view or
listen to a different source at a different volume level
from the main zone (Zone 1).
Zone 3 (AVR600/AV888 only) provides for a third living
space to have a copy of the audio signal in Zone 2 at a
different volume level.
Extended front panel menu
Pressing the MEnu key and holding it for longer than
four seconds will bring up the Extended Menu, allowing
you to perform the following:
Restore to factory defaults
This option allows you to restore all settings on your
AVR500/AVR600/AV888 to the defaults that it left
the factory with. Note that this also erases any secure
backups stored on the unit.
Restore secure backup
Store secure backup
This option allows you to restore from and store to a
PIN-protected copy of your settings. The default PIN is
1234.
Change remote code
The default RC5 system code the unit responds to is
16. If required, for example due to another device in
your system also using this RC5 system code, it can be
changed to 19.
Software versions
Information on the software version of the unit can be
found here.
Updating firmware using a PC
Using a PC application (available on request from
Arcam), you can update the firmware in your AVR500/
AVR600/AV888 using the back panel RS232 port
connected to your PC.