Technical data, Installation, Replacing the lamp – AEG SKS68849F1 User Manual
Page 43: Closing the door, Positioning

Problem
Possible cause
Solution
The temperature in the ap-
pliance is too low/high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at
the same time.
Store less products at the same
time.
The temperature in the re-
frigerator is too high.
There is no cold air circulation
in the appliance.
Make sure that there is cold air
circulation in the appliance.
Replacing the lamp
The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height
1030 mm
Width
560 mm
Depth
550 mm
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must
ensure that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
Technical data
43