AEG AGS58200F0 - Manual (Page 19)

• Connect to potable water supply only
(If a water connection is foreseen).
1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.
1.7 Environment Protection
This appliance does not contain
gasses which could damage the
ozone layer, in either its refriger-
ant circuit or insulation materials.
The appliance shall not be dis-
carded together with the urban
refuse and rubbish. The insula-
tion foam contains flammable
gases: the appliance shall be dis-
posed according to the applica-
ble regulations to obtain from
your local authorities. Avoid
damaging the cooling unit, espe-
cially at the rear near the heat ex-
changer. The materials used on
this appliance marked by the
symbol
are recyclable.
2. CONTROL PANEL
1 2 3 5 4
1
Pilot light
2
Temperature regulator
3
FROSTMATIC light
4
FROSTMATIC switch
Acoustic alarm reset switch
5
Alarm light
2.1 Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator
clockwise to a medium setting.
3. The Pilot light will light up and a
sound is on only for 2 sec. indicating
that the appliance is powered.
4. The Alarm light will blink and the
sound signal alarm will get on, indi-
cating that the temperature inside
the appliance is too high.
5. Push the FROSTMATIC switch and
the sound signal alarm will get off.
6. Push the FROSTMATIC switch once
again and the FROSTMATIC light
will light up. The freezer will start to
operate.
2.2 Switching off
1. To turn off the appliance, turn the
Temperature regulator to the "O"
position and a sound is on only for 2
sec.
2. The pilot light will switch off.
2.3 Temperature regulation
The temperature within the appliance is
controlled by the Temperature regulator
situated at the top of the cabinet.
To operate the appliance, proceed as
follows:
• turn the Temperature regulator to-
ward lower settings to obtain the mini-
mum coldness.
• turn the Temperature regulator to-
ward higher settings to obtain the
maximum coldness.
A medium setting is generally
the most suitable.
ENGLISH
19