AEG Voxtel roam - Manual (Page 6)

6
6 INSTALLING YOUR DEVICE
6.1 Connecting the charger (see P2)
tPlug the power adapter into the charger pod.
tPlug the other end of the power adapter into a power outlet.
Warning:
Use only the power adapter supplied with the product.
6.2 Installing and charging the wireless headset (see P3)
tAttach the ear hook to the headset body as indicated. The ear hook
can be attached according to your preference to wear the headset
on the left or right ear.
tPut the installed wireless headset in the charger pod When the
wireless headset is fully charged, the LED on the headset will light
on steadily blue.
6.3 Registration
To work as the handset extension, the headset must be registered to
a GAP compatible DECT telephone. You can check this in the user
guide of your telephone.
tBefore starting the registration process the base pin should be set
to 0000. This is the usual default for most DECT telephones. If you
need to change it, then follow the instructions in the user guide
supplied with your telephone.
tPut the DECT base in registration mode. Press and hold the paging
key for 4 seconds on the base and then release. (Refer to DECT
telephone user manual.)
tWhen the headset is ON, press and hold the volume up together
with the volume down key until the LED on wireless headset
toggling between red and blue.
tPlace the unregistered wireless headset in the charger pod.
>A long beep tone is generated and the LED turns on blue for a
while if the registration is successful.