AEG HK634200XB - Manual (Page 17)

Problem Possible cause and remedy
? comes on • No cookware on the cooking zone. Put cookware on the cook-
ing zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is too small for
the cooking zone. Move cookware to a smaller cooking zone.
E and number comes on. There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the service centre.
E4 comes on There is an error in the appliance, because a cookware boils dry.
The protection against become too hot for the cooking zone op-
erates. The Automatic Switch Off operates.
Deactivate the appliance. Remove the hot cookware. After, ap-
proximately 30 seconds activate the cooking zone again. The er-
ror message should go out of the display, residual heat indicator
can stay. Let the cookware become sufficiently cool and check it
with the section Cookware for the induction cooking zone.
If you tried the above solutions and cannot repair the problem, speak to your dealer or the
customer service. Give the data from the rating plate, three digit letter code for the glass
ceramic (it is in the corner of the glass surface) and an error message that comes on.
Make sure, you operated the appliance correctly. If not the servicing by a customer service
technician or dealer will not be free of charge, also during the warranty period. The instruc-
tions about the customer service and conditions of guarantee are in the guarantee booklet.
INSTALLATION INSTRUCTIONS
Before the installation, note down the serial number (Ser. Nr.) from the rating plate.The
rating plate of the appliance is on its lower casing.
HK884400XG 949 595 186 00
58 GBD C3 AU 220-240 V 50-60 Hz
7,4 kW
Induction 7,4 kW
AEG
The Safety Instructions
WARNING!
You must read these!
• Make sure that the appliance is not damaged because of transportation. Do not connect
a damaged appliance. If it is necessary, speak to the supplier.
• Only an authorized servicing technician can install, connect or repair this appliance. Use
only original spare parts.
• Only use the built-in appliances after you assemble the appliance into correct built-in
units and work surfaces that align to the standards.
• Do not change the specifications or change this product. Risk of injury and damage to
the appliance.
Installation instructions 17