beautypg.com

Replacing the lamp, Closing the door – AEG SCT51800S0 User Manual

Page 15

background image

Problem

Possible cause

Solution

The temperature in the re-

frigerator is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each

other.

Store products so that there is

cold air circulation.

There is too much frost.

Food is not wrapped correctly.

Wrap the food correctly.

The door is not closed correctly.

Refer to "Closing the door".

The temperature regulator is not

set correctly.

Set a higher temperature.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same

time slide the cover in the direction of the

arrow.

3. Replace the lamp with one of the same

power and specifically designed for

household appliances. (the maximum

power is shown on the lamp cover).

4. Install the lamp cover by sliding it into its

original position.

5. Switch on the appliance.
6. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

What to do if…

15