AEG F99015VI0P - Manual (Page 12)

5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
20
30 M AX
1 2 3
4 + -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when the display shows 2 horizon-
tal status bars. If the control panel does
not show this condition, press RESET.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press Program again and again until
you see in the display the number of
the programme you want to set. The
programme number flashes. If you
want you can set the applicable op-
tions.
4. Close the appliance door, the pro-
gramme starts. The programme du-
ration starts to decrease with steps of
1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is comple-
ted, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press RESET. The display shows 2
horizontal status bars.
2. Set the programme again.
Cancelling the programme
1. Press RESET. The display shows 2
horizontal status bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
12 www.aeg.com