AEG S54000KMW0 - Manual (Page 16)

12. Remove and install the handle 4)
on the
opposite side.
13. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the above mentioned operations, contact the near-
est After Sales Service Force. The After Sales Service specialist will carry out the reversibil-
ity of the doors at your cost.
Plug socket
CAUTION!
Make sure that the mains cable can move freely.
The plug socket necessary for connection of your
appliance to the electricity supply should be posi-
tioned so that it is possible to pull out the appli-
ance plug.
If your appliance is installed under a continuous
worktop, the plug socket should be provided as
shown.
Electrical Connection
CAUTION!
Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
4) If foreseen
16 Installation