AEG DC4003000M - Manual (Page 10)

You can use the functions
Duration
and End at
the same time to set the
time for how long the
appliance should operate
and when the appliance
should deactivate. This lets
you activate the appliance
with a delay in time. First set
the Duration
and then
the End .
6.2 Setting the clock functions
For Duration and End , set an
oven function and temperature of
cooking. This is not necessary for the
Minute Minder .
1. Press again and again until the
indicator for the necessary clock
function starts to flash.
2. Press or to set the time for the
necessary clock function.
The clock function operates. The display
shows the indicator for the clock function
you set.
For the Minute Minder
function the display shows
the time left.
3. When the time ends the indicator of
the clock function flashes and an
acoustic signal sounds. Press a
button to stop the signal.
4. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
With the Duration and
End functions, the
appliance deactivates
automatically. The functions
work only for the main oven.
6.3 Cancelling the clock
functions
1. Press the again and again until
the necessary function indicator
flashes.
2. Press and hold .
The clock function goes out after some
seconds.
7. USING THE ACCESSORIES
WARNING!
Refer to Safety chapters.
7.1 Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
Deep pan:
Push the deep pan between the guide
bars of the shelf support.
www.aeg.com 10