AEG F88419W0P - Manual (Page 16)

Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2 How to activate the rinse
aid dispenser
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
“Setting and starting a programme”.
2. Press and hold, at the same time, De-
lay and Start until the indicators of
, and
start to flash.
3. Press Option .
• The indicators of
and
go off.
• The indicator continues to
flash.
• The display shows the current set-
ting.
Rinse aid dis-
penser off
Rinse aid dis-
penser on
4. Press Option to change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth
(mm) 596 / 850 / 610
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2) max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.10 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
16 www.aeg.com