AEG F88419W0P - Manual (Page 10)

, and
start to flash.
3. Press Program,
• The indicators of
and
go off.
• The indicator of
contin-
ues to flash.
• The display shows the current set-
ting of the water softener. E.g.
= level 5.
4. Press Program again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6.2 Filling the salt container
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
6.3 Filling the rinse aid dispenser
M AX
1 2 3
4 + -
A B
D
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
7. DAILY USE
1. Open the water tap.
10 www.aeg.com