AEG SCS51800F0 - Manual (Page 18)

Problem Possible cause Solution
Temperature cannot be
set .
FROSTMATIC or COOLMATIC
functions switched on.
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set
the temperature until the func-
tion has reset automatically. Re-
fer to "FROSTMATIC or COOLMAT-
IC function"..
The temperature in the
appliance is too low/high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
The temperature in the re-
frigerator is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each
other.
Store products so that there is
cold air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Set a higher temperature.
Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
2. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cover).
3. Install the lamp cover by fixing it into its
original position.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
18 What to do if…