AEG MULTI-COMPRESSOR MV 10 - Manual (Page 20)

20
2.2.30 Do not use damaged valve adapters! The
air pressure may cause it to burst. Attention!
Risk of injury!
2.2.29 For safety reasons only inflate the item in
short intervals and occasionally check the air
pressure on the manometer and the item being
inflated.
2.2.28 Explosive substance and
object warning! Do not inflate
swimming aids, personal protective
equipment or inflatable boats.
2.2.27 The unit features Class 1 LEDs. Do not aim
the LED beam at the eyes of other individuals or
animals!
2.2.26 Warning! LED emission!
Avoid damage to the eye! Do not
look directly into the unit's LED light for
extended periods or without suitable safety
goggles.
2.2.25 Do not use the compressed air generated
for commercial purposes or for food-, pharma-
ceutical-, diving- or medical purposes.
2.2.24 Immediately shut the unit off after a
maximum of 10 minutes of operation or in the
event of overheating by setting the power switch
to ( O ). Allow the unit to cool down for at least
10 minutes until the regular operating temperature
has been reached and the unit is again ready for
use.
2.2.23 Only carry the unit by the handle. Keep
the handle free of oils, greases and moisture.
2.2.22 Do not overload the unit.
2.2.21 Do not expose the unit to temperatures
over 60 °C.
2.2.20 Always follow the pressure specifications
of the item to be inflated and the manufacturer
instructions.
2.2.19 Especially after inflating tyres on vehicles,
motorcycles and trailers check the air pressure
with a suitable external pressure gauge. Even
mildly incorrect air pressures can impact the
driving characteristics. Attention! Risk of
personal injury and property damage!
2.2.18 To prevent malfunctions or the product
being inflated bursting, check the air pressure
with a suitable external pressure gauge whilst
inflating. The unit's manometer is not calibrated,
thus the values shown should only be considered
air pressure guidelines. The manometer does not
indicate a binding, accurate air pressure. Please
refer to the technical data (item 6.0) for mano-
meter measuring tolerances. Attention! Risk of
personal injury and property damage!
2.2.17 If dusty, clean the area around the valve
before inflating. Wear a dust mask to protect your
respiratory system. Attention! Risk of
personal injury and property damage!
2.2.16 Do not aim the compressed air stream at
individuals, animals, dust, dirt, chemicals, acids,
gasses, objects of any type, or yourself.
Attention! Risk of personal injury and
property damage!
2.2.15 Always power the unit off before switch-
ing valve adapters.
2.2.14 Do not use the unit when fatigued or
under the influence of medications, drugs or
alcohol.
2.2.13 Keep children and other individuals away
from the unit during operation.
2.2.12 Incorrect installation of the valve adapter
or incorrectly attaching or inserting the valve
adapters on / in the item to be inflated may result
in an untight connection between the unit and
product. The leaking air will result in a pressure
drop and subsequently incorrect air pressure
readings.
2.2.11 If you are unsure about the vehicle
function and operation please consult a qualified
professional.
2.2.10 Improper use of the unit may damage
vehicle electronics. This may then cause an
accident or fire. Attention! Risk of property
damage and personal injury!
2.2.9 Verify the ignition and all loads inside the
vehicle are switched off before connecting the unit
to the 12 V vehicle outlet!
2.2.8 In the event of malfunctions or damage
immediately shut the unit off and disconnect from
the 12 V vehicle outlet or the 12 V power station!
97181_Multi-Kompressor_MV_10_Manual _02_08_2012_Print
Donnerstag, 2. August 2012 13:03:17