AEG X66453BV0 - Manual (Page 10)

MAINTENANCE AND CLEANING 10
MAINTENANCE AND CLEANING
Opening and locking panels
• Open the Panels by pulling from the centre.
• The top panel is locked by means of a rod, the mobile end of
which is inserted into the hole provided on the side of the Hood
body.
• The lower panel is unlocked by removing the fixing pin on the
left to open it. It is fitted with a safety cable to prevent it from
dropping down and hitting the lower part of the hood.
Before carrying out any maintenance or leaning isolate
the cooker hood from the mains supply.
The cooker hood must be kept clean, as a build up of
grease or fat can be a fire hazard.
External Cleaning
The metal casing, grille and chimney should be cleaned at least
once a month to keep it looking like new. Wipe over the hood
with a soft cloth wrung out in mild
soapy water and then dry thoroughly.
Never use scouring pads or abrasive cleaners as they may scratch
or damage the surfaces.
Always wear protective gloves when cleaning the hood.
Never use scouring pads or abrasive cleaners.
Never use excessive amounts of water when cleaning
particularly around the control panel.
Resetting the alarm signal
• Turn the Lights and the Suction motor off.
• Press button
H and hold for at least 2 seconds, confirmation
is provided by the fact that the Led goes out.
Metal Grease Filters
• These filters can be washed in a dishwasher, and need to be
cleaned when the Led on Button H lights up in a continuous
manner or at least once every approximately two months'
use, or more frequently in the case of particularly intensive
use.
To Remove the Grease Filter
• Open the panel by pulling from the center.
• Remove the Filters one at a time, supporting them with one
hand while you pull the lever down with the other.
• Wash the Filters without bending them, and leave them to
dry before replacing them.
• Replace the filters, taking care to ensure that the handle is
fac-ing outwards.