AEG HK624010FB - Manual (Page 12)

Problem Possible cause Remedy
Automatic Heat Up function
does not operate. The zone is hot. Let the zone become suffi-
ciently cool.
The highest heat setting is
set. The highest heat setting has
the same power as the func-
tion.
You decreased the heat set-
ting to
.
Start from and only in-
crease the heat setting.
You cannot activate the out-
er ring. Activate the inner ring first.
There is a dark area on
the multiple zone.
It is normal that there is a
dark area on the multiple
zone.
The sensor fields become
hot. The cookware is too large or
you put it too near to the
controls. Put large cookware on the
rear zones if possible.
comes on.
Automatic Switch Off oper-
ates. Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates. Refer to "Daily use" chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down
the information bellow from the rating
www.aeg.com 12