AEG SCN71800S0 - Manual (Page 14)

Problem Possible cause Solution
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products
do not touch the rear
plate.
Temperature cannot
be set . FROSTMATIC or COOL-
MATIC functions switched
on. Switch off FROSTMATIC or
COOLMATIC manually, or
wait to set the temperature
until the function has reset
automatically. Refer to
"FROSTMATIC or COOL-
MATIC function"..
The temperature in
the appliance is too
low/high. The temperature regula-
tor is not set correctly. Set a higher/lower temper-
ature.
The door is not closed
correctly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
14 www.aeg.com