AEG L61271WDBI - Manual (Page 39)

Water-stop device
A
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and
contact the service centre to replace
the hose.
WATER DRAINAGE
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the water tap or
the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into
a drain pipe at a height of not less
than 60 cm (23.6”) and not more than
100 cm (39.3”). The end of the drain
hose must always be ventilated , i.e.
the inner diameter of the drainpipe
(min. 38 mm — min. 1.5”) must be
larger than the external diameter of
the drain hose.
ENGLISH 39