beautypg.com

Replacing the lamp, Closing the door – AEG SCZ71800F0 User Manual

Page 15

background image

Problem

Possible cause

Solution

The temperature in the re-

frigerator is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each

other.

Store products so that there is

cold air circulation.

There is too much frost.

Food is not wrapped correctly.

Wrap the food correctly.

The door is not closed correctly.

Refer to "Closing the door".

The temperature regulator is not

set correctly.

Set a higher temperature.

Replacing the lamp

1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the illus-

tration).

4. Replace the used lamp with a new lamp

of the same power and specifically de-

signed for household appliances. (the

maximum power is shown on the lamp

cover).

5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains socket.
8. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

What to do if…

15