AT&T 1872 - Manual (Page 9)

T E L E P H O N E M E M O R Y
This telephone can store up to 16 telephone
numbers, each up to 16 digits long.
NOTE: The number stored in memory may
be lost if the batteries are missing or low
on power and there is a power failure.
STORING A NUMBER IN MEMORY
1 Press
p.
2 Enter the telephone number. To insert a
hyphen between digits, press
_. The
screen displays the number as you
enter it.
3 Press a memory button to store the
number in a white space (for one-touch
dialing)
— OR —
Press
W and then a memory button
to store the number in a grey space (for
two-touch dialing).
You will hear two beeps to confirm the
number has been stored. If you hear a long
sequence of beeps and the screen displays
a series of “Es,” you have not correctly
stored the number. Try again.
NOTE: You may choose to store
emergency numbers in memory locations.
This feature is provided only as a
convenience and the manufacturer
assumes no responsibility for customer
reliance upon the memory feature.
DIRECTORY CARD
Remove the plastic cover from the memory
button area to write your telephone
numbers for both lines in the spaces pro-
vided on the card.
You can also write names or telephone
numbers for each memory location. The
eight white spaces on the directory card
are for numbers you can dial by pressing
the memory button next to the number. The
eight gray spaces are for numbers you can
dial by pressing
W, then the memory
button next to the number.
STORING A PAUSE
IN A MEMORY DIAL NUMBER
To store a 2-second pause as part of a
number, press
_ twice (a P is
displayed).
To store a 30-second “halt” as part of a
number, press
_ 3 times (an H is
displayed).
To resume dialing after a “halt,” press a
memory button.
DIALING A STORED NUMBER
1 Lift the handset
— OR —
Press
K
— OR —
Press
L or l.
2 Listen for a dial tone.
3 Press a memory button to dial a one-
touch number
— OR —
Press
W and then a memory button
to dial a two-touch number.
VIEWING NUMBERS IN MEMORY
To view a number when the phone is not
in use, press the memory button (or
W
and then the memory button) where the
number is stored. The number is displayed
but not dialed.
CLEAR A MEMORY LOCATION
1 Press
p.
2 Press the memory button (or press
W
and then the memory button) of the
location you want to clear.
STORING A NUMBER JUST DIALED
1 Press
p.
2 Press
(.
3 Press a memory button (or
W and
then a memory button).