AEG SCT71900S0 - Manual (Page 49)

49
The cooler needs air
The cooler door seals the installed unit almost completely, so an air vent must be pro-
vided in the base of the housing. Warmed air must be conducted via the ventilation
shaft to the rear wall of the housing and then expelled upwards. The ventilation
channels should measure at least 200 cm 2 in cross-section.
Warning! To ensure the proper functioning of the appliance, air vents should never
be blocked or covered.
Installation
Scale drawing
min. 200 cm 2
min. 200 cm 2
50
200 cm 2
200 cm 2
874–880
560 min.
550 min.
547 566
873
50